Buy Taper Shank Chucking Reamers Online |Indian Tools|Addison|MIRANDA TOOLS| India
Home Tooling and Cutting Reamers Taper Shank Chucking Reamers

Taper Shank Chucking Reamers Online Store

(1-2 products of 2)

Taper Shank Chucking Reamers

A reamer is a metalworking tool used to create an accurate sized hole. They may be used as a hand tool or in a machine tool, such as a milling machine or drill press. A typical reamer consists of a set of parallel straight or helical cutting edges along the length of a cylindrical body. Each cutting edge is ground at a slight angle and with a slight undercut below the cutting edge. Reamers must combine both hardness in the cutting edges, for long life, and toughness, so that the tool does not fail under the normal forces of use. They should only be used to remove small amounts of material. This ensures a long life for the reamer and a superior finish to the hole. The spiral may be clockwise or counter-clockwise depending on usage. For example, a tapered hand reamer with a clockwise spiral will tend to self feed as it is used, possibly leading to a wedging action and consequent breakage. A counter-clockwise spiral is therefore preferred even though the reamer is still turned in the clockwise direction. For production machine tools, the shank type is usually one of the following: a standard taper (such as Morse or Brown & Sharpe), a straight round shank to be held by a collet, or a straight round shank with a flat for a set screw, to be held by a solid toolholder. For hand tools, the shank end is usually a square drive, intended for use with the same type of wrench used to turn a tap for the cutting of screw threads

Please enter your e-mail address and we will send you a confirmation mail to reset your password.

Forgot Password

Reset Password


Your password has been reset successfully.
To sign in with your new password,

Thanks for submitting your feedback! Rate recent shopping experiences

Rate your shopping experience

Based on shopping experience of how likely are you to recommend industrybuying to a friend or colleague?

Not at all
May be
Yes, for Sure!
Thanks for submitting your feedback!